These parts are all top quality and are professionally assembled, ready for professional installation in your car.
Lifetime Warranty - On the steering knuckle. This covers normal wear and tear.
2 Year Warranty on the Timken Bearing when professionally installed according to recommended installation procedures. This cover a 1 time replacement of the bearing.
AARodriguez is not responsible for labor expenses, towing expenses, additional parts expenses, rental car, or other direct or indirect expenses associated
with the failure of ordered components. It is critical to follow the installation procedure listed below. There are instructions below on how to perform the final
tightening procedure. In addition, there are excellent videos online that show step by step how to remove the old part and install the new part. However,
because many DIY installers have failed to follow the correct procedure this warranty is only valid with documentation of a professional installation.
Front Axle Nut, final tightening - recommended procedure
- Tighten 12-point nut to 200 Nm (147 ft-lb) and then loosen one half turn.
- Tighten to 50 Nm (37 ft-lb) and turn an additional 60 degrees.
- Weight of vehicle MUST be on its wheels for final torquing.
Failure to follow this procedure could result in premature bearing failure that is not covered by warranty.
Proper installation by a certified mechanic is recommended.
1998 - 2010 VW Beetle APK, ALH, AVH, AQY, ALH, AWH, AYD, ATD, AEG, AZG
1999 - 2005 VW MK4 Jetta AEG,ALH,AZG,AVH
Other Details2 year Warranty on Timken Bearing Lifetime Warranty on Steering Knuckle & Hub (Normal Wear & Tear)
3 Reviews Hide Reviews Show Reviews
Like most people ordering this knuckle my calliper pin threads had stripped wish I knew that before I had pressed in a new hub and bearing in my old spindle.
New part fit great and installed in like 5 mins.
I just wish it came with ball joint and ABS sensor installed
When I had my car aligned the shop was unable to to get acceptable ranges and quoted me $700 in work that needed to be done. I looked into it myself and found the ball joint was bad, and the hole for the ball joint was damaged. This part fit perfectly and saved me a lot of time and headaches in trying to remove the bearing from my old knuckle and pressing it into a new one. It arrived 5 days after I ordered it with no hassles. I just had my car realigned and everything worked perfectly. Definitely worth the money.
As far as I know no one sells this loaded. It comes with everything but the ball joint and abs sensor which can be reused off your old knuckle. I love these guys, replied to all my questions very quickly. Shipped super fast couldn't be any happier.