Downpipe MK5 Jetta 1.9L BRM TDI:
Proudly made in Canada by BuzzKen
Increasing the performance of your BRM TDI?
Start by replacing the restrictive factory exhaust with this mandrel bent downpipe and allowing the exhaust to flow freely!
This downpipe is built to last with 409 grade stainless steel and a high quality flex pipe, it will also retain the 02 sensor as the proper bung have been provided.
- Great when used with an upgraded turbo
- Rated for up to 250 WHP
- Lower EGTs
- 409 stainless steel from North America mills
- 2.5″ OD 16 gauge tubing
- 100% bolt-on
Will fit the following North American spec vehicles with DPF (diesel particulate filter):
VW MK5 Jetta 1.9L BRM TDI (2005 - 2006)
For Off-Road Use Only
2 Reviews Hide Reviews Show Reviews
I can actually hear the turbo now and it just has an over all better tone. Very worth it. Easy to install and shipping was fairly quick. 10/10 would recommend.
I ordered the 2.5" pipe for my BRM. Build quality looks good, and fitment is perfect, no surprises there. Oxygen sensor bung is located in a better spot than factory, in my opinion. It mounts the sensor at an angle pointed straight towards the back of the car, so as to keep the harness away from the turbo.
I added some 2.5" pipe straight out the side before the rear wheel, but it is a bit loud, and I am going to install an in-line resonator or glasspack to mellow it down a bit.
The turbo noise is glorious though.